We have moved at community.getvera.com

Author Topic: A report to tell "slow" device  (Read 969 times)

Offline bobbydoedoe

  • Sr. Newbie
  • *
  • Posts: 34
  • Karma: +1/-0
A report to tell "slow" device
« on: April 02, 2018, 10:45:43 am »
I am using PLEG, and i have a condition setup where if the doorlock unlocks, then switch mode to home and turn on lights if it is Night time.  And lately, I have noticed the lights are turning on after 10 and sometime even 60 seconds after the doorlock is unlocked.  I am thinking there are devices in the house that are taking longer to poll and delaying the chain of action to run.  Is there a report that can tell me which devices are "slow" therefore causing this delay?

Offline Sorin

  • Administrator
  • Hero Member
  • *****
  • Posts: 1134
  • Karma: +103/-11
Re: A report to tell "slow" device
« Reply #1 on: April 03, 2018, 06:09:21 am »
The built-in function that could tell IF a device is "slow", is the "Stress test" command which can be found on device settings->Advanced->commands

This is ok if you don't have many devices to go through. Otherwise, Customer Care can give you a hand as well.
« Last Edit: April 03, 2018, 06:33:56 am by Sorin »
Sorin M. ▾ Community Manager
Vera Control, Ltd. ▾ Smarter Home Control  ▾ support@getvera.com ▾www.getvera.com ▾ +1 (866) 966-2272

HOURS OF OPERATION for Customer Care Department - 24/7