We have moved at community.getvera.com

Author Topic: Including Everspring Light controls  (Read 1816 times)

Offline svendth

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Including Everspring Light controls
« on: September 19, 2011, 05:01:41 pm »

I cannot include Everspring Light Controls, and Im unable to locate any detailed manuals. I have seen the film on Youtube, but it did not help.

How do i activate this device?



Offline HouseBot

  • Full Member
  • ***
  • Posts: 210
  • Karma: +1/-1
Re: Including Everspring Light controls
« Reply #1 on: September 20, 2011, 01:22:51 am »
Most of the Z-way things is built on the same chip. You put that chip in to include mode by pressing the button 3 times within 1,5 seconds. Or as I find out was easiest. Just press it as many time you can for a short period...  8)
I noticed on Vera2 that I got diffrent result from including devices via the wizard and the add/remove devices button. Try both!

Good Luck! Dont give up, it took me a evening to have every device added. Keep them close to the vera and start out with 1 at a time.

Offline svendth

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: Including Everspring Light controls - NEXT QUESTION
« Reply #2 on: September 27, 2011, 05:02:23 pm »
Thank You! It worked beautyfully and at once.

How do i make a temperature sensor (sss) control an electric radiator using the everspring control forinstance to avoid freezing waterpipes in a room?

Can I do it using VERA scenes?