Author Topic: How do I make my lights work again?  (Read 1580 times)

Offline michaelthoward

  • Newbie
  • *
  • Posts: 18
  • Karma: +0/-0
How do I make my lights work again?
« on: September 30, 2011, 08:03:18 pm »
I have approx 25 Leviton Vizia RF devices in my house. Config was working fine with ControlThink ThinkEssentials.

Just bought Vera. I didn't expect the transition to be easy. But I have now spent many hours on this ... the remote controllers aren't associated with the switches/dimmers ... the lights don't work ... and it is dark outside.

I would appreciate it if someone would give me some simple & explicit instructions on how to associate a single dimmer with a single switch (scene controller) in a normal 3-way configuration.


Thanks,
Michael

Offline grybrd

  • Full Member
  • ***
  • Posts: 218
  • Karma: +0/-0
Re: How do I make my lights work again?
« Reply #1 on: September 30, 2011, 08:50:20 pm »
@Michael ... what leviton devices are you talking about??   If it is a RZCZ1 controller there may be a problem with Vera.  I have reported it to MCV.

Offline michaelthoward

  • Newbie
  • *
  • Posts: 18
  • Karma: +0/-0
Re: How do I make my lights work again?
« Reply #2 on: September 30, 2011, 09:04:26 pm »
If it is a RZCZ1 controller there may be a problem with Vera.  I have reported it to MCV.

Yes, the one-zone controller that I have been struggling with is a VRZC1.

I also have approx 5 VRCZ4 controllers ...

Q: Any issues with the VRCZ4 controller?


Regardless of these issues,

Q: What in the world are the Vera/MiOS recommended steps for associating a controller with a device?

Q: Do I need to make a scene for everything? (although I tried that unsuccessfully)


Thanks,
Michael