Author Topic: Watercop integration  (Read 357 times)

Offline mikoz

  • Full Member
  • ***
  • Posts: 123
  • Karma: +1/-6
Watercop integration
« on: May 04, 2018, 02:48:36 pm »
Hi all,

I bought a Watercop Zwave 3/4" water shut off valve.   It's intended to be a water shut off valve, but I am using it just as a valve.  The ON position is actually closing the pipe, off opens it (a bit backwards in my application but it's no big deal).   Anyway, I am using it to control my misting system. 
   It works great, however, Vera constantly reports the node as "busy", but it still works fine. 
I suspect this is because it takes the unit a second or two to transition from Open to Closed (or close to open), but am not certain. 

Is anyone else using this? If so, how are you getting around this?  I setup the device as GE outdoor switch because there seemed to be no better fit, maybe that's the issue... if so, what should it be? 

Offline Jamr

  • Hero Member
  • *****
  • Posts: 738
  • Karma: +22/-8
Re: Watercop integration
« Reply #1 on: June 11, 2018, 04:28:17 pm »
I am thinking about getting a few of these. Are you still having the node report back as busy?
Have you tried calling Vera to see if there is a fix for this?
Curious. Thanks.

Offline leedavidr

  • Jr. Member
  • **
  • Posts: 84
  • Karma: +0/-0
Re: Watercop integration
« Reply #2 on: June 24, 2018, 08:09:53 am »
I have a Fortrezz Water valve, and I don't remember how I included it exactly.  It is grouped with my light switches in my devices, but switches from closed to open which at least to me makes more sense.  It also remains busy for a while after it switches but can be switched back and forth during that time despite the message.

Offline kwieto

  • Hero Member
  • *****
  • Posts: 587
  • Karma: +22/-12
Re: Watercop integration
« Reply #3 on: July 01, 2018, 03:11:51 pm »
Can you tell me what device category and subcategory you have, and what are device xml and json files?

Offline leedavidr

  • Jr. Member
  • **
  • Posts: 84
  • Karma: +0/-0
Re: Watercop integration
« Reply #4 on: July 19, 2018, 04:36:12 pm »
See attachment