We have moved at community.getvera.com
« previous next »
Pages: [1]   Go Down

Author Topic: 2GIG-TILT1-345 Device Problem  (Read 335 times)

Offline ZW-Tom

  • Jr. Member
  • **
  • Posts: 76
  • Karma: +8/-2
2GIG-TILT1-345 Device Problem
« on: May 23, 2018, 09:28:41 pm »
I have a new VeraSecure that I just installed two 2GIG-Tilt1-345 sensors. They install as Motion Sensors. They seem to work, but why are they not installing as Tilt sensors?

device_type: MotionSensor:1
device_file: D_MotionSensor1.xml
device_json: D_MotionSensor1.json

Anyone else have this or is it unique to the new firmware?

Tom
Logged

Offline Don Phillips

  • Hero Member
  • *****
  • Posts: 1464
  • Karma: +41/-36
Re: 2GIG-TILT1-345 Device Problem
« Reply #1 on: May 23, 2018, 10:17:57 pm »
Logged
Vera 3, 1.7.1040, CT101, Everspring Motion, GE/Jasco Switch/Dimmer, Leviton outlet, AeonLabs sensor, NuTone garage door, Blue Iris, Sricam SP011, iPhone locator, APCUPSD, VeraMate, VeraAlerts, PLEG, House Modes, Countdown Timer, DVR, Virtual/Multi Switch, LB60Z-1 bulb, Hue, Alexa, Zooz 4-1

Offline ZW-Tom

  • Jr. Member
  • **
  • Posts: 76
  • Karma: +8/-2
Re: 2GIG-TILT1-345 Device Problem
« Reply #2 on: May 30, 2018, 04:20:47 pm »
Quote from: Don Phillips on May 23, 2018, 10:17:57 pm
Try playing with device categories: http://wiki.micasaverde.com/index.php/Luup_Device_Categories.

Hi Don. Not sure if you are using 2GIG, but Vera will not change edited device categories for 2gig. Change it from 4,3 to 4,1 and the next Lua reload it will change it back (4,3 = motion).
You can change device_type, device_file and device_json to door sensor and it will look like a door sensor, but will not allow change to device categories.

The bottom line: Vera identified it as "works with Vera". Well, although it understands a state change as a motion sensor, it does not look like a tilt sensor. It also takes about 4 seconds to change state.

Thanks, Tom
Logged
Pages: [1]   Go Up
« previous next »