Author Topic: Problems linking stella Z radiator valve to Vera Plus  (Read 485 times)

Offline Excrewman

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Problems linking stella Z radiator valve to Vera Plus
« on: February 18, 2017, 12:25:48 pm »
I have a vera plus which was linked up to two stella z radiator valves, I had to do a hard reset of my vera and now I can't get the stella z valves to link. Each time I press the button on the stella for 5 seconds like the manual says i get constant flashing green LED and the vera doesn't detect the valve. IS there an issue because they were previously linked maybe? I thought the hard reset would have excluded them so it should be a straight forward inclusion when I rebuilt the vera.

Any ideas?
« Last Edit: February 18, 2017, 12:27:19 pm by Excrewman »

Offline bogdanf

  • Steering Box Fanclub
  • Administrator
  • Full Member
  • *****
  • Posts: 222
  • Karma: +8/-1
  • Did you change the oil ?
Re: Problems linking stella Z radiator valve to Vera Plus
« Reply #1 on: September 04, 2018, 03:46:01 pm »
The hard reset on Vera will only erase the info from the Z-Wave chip of the controller.
On the Stella device, you will still need to perform the exclusion.