Author Topic: Strange child device - Qubino Flush 1D Relay  (Read 143 times)

Offline Kositch

  • Sr. Newbie
  • *
  • Posts: 25
  • Karma: +0/-0
Strange child device - Qubino Flush 1D Relay
« on: June 23, 2018, 09:54:29 am »
Hello,

I have just successfully installed Qubino Flush 1D Relay (ZMNHND1) to control my garage door and after the inclusion there is parent device "Temperature", which is OK - Qubino supports temp sensor, which I don't have but it also created strange device "_GET_LANG_" (see screenshot) which has nothing in its configuration (Device Options, Control - everything is blank).

I don't know what it is and how to get rid off it, I have tried to delete it, but it recreated itself again.

BTW: Controlling of garage doors works perfectly with this Relay, it is also powered by 24V spare outputs on my Garage main controller.

Thanks for advice!
« Last Edit: June 23, 2018, 09:56:14 am by Kositch »

Offline fooey

  • Sr. Newbie
  • *
  • Posts: 25
  • Karma: +1/-0
Re: Strange child device - Qubino Flush 1D Relay
« Reply #1 on: June 27, 2018, 06:19:19 am »
I had the same with my Flush 2 Relay - I just hid it using the luup.attr_set("invisible", 1, DEVICEID)

Offline Kositch

  • Sr. Newbie
  • *
  • Posts: 25
  • Karma: +0/-0
Re: Strange child device - Qubino Flush 1D Relay
« Reply #2 on: June 27, 2018, 06:50:52 am »
I had the same with my Flush 2 Relay - I just hid it using the luup.attr_set("invisible", 1, DEVICEID)

Thanks, that is what I needed to know - it is normal behaviour, so nothing bad happened by me :-)