Author Topic: Aeotec Multisensor 6  (Read 267 times)

Offline boily

  • Newbie
  • *
  • Posts: 4
  • Karma: +0/-0
Aeotec Multisensor 6
« on: June 29, 2018, 12:21:08 am »
Hi Guys I have a multisensor 6 set up to turn on some lights. What my problem is when the multisensor detects motion the first time it works fine but say for example the lights turn off 2mins later and I walk past the multisensor it wont turn back on immediately I might have to wait 5mins is there are setting I can change for this.
thanks  :)

Offline Tillsy

  • Full Member
  • ***
  • Posts: 207
  • Karma: +13/-5
Re: Aeotec Multisensor 6
« Reply #1 on: June 29, 2018, 07:21:30 am »
Parameter 3 (1 byte in size) controls the motion time - minimum value of 10 seconds.

Offline seeley243

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Re: Aeotec Multisensor 6
« Reply #2 on: December 11, 2018, 11:59:59 am »
Parameter 3 (1 byte in size) controls the motion time - minimum value of 10 seconds.

Tillsy:

Where can I find that parameter on the Vera Plus.  I have looked under the settings for the Aeotec Multi-sensor and can not find it.  Thanks