Vera - Smarter Home Control Forum

General => Lock, Motion & Security Control => Topic started by: SystemaX on May 15, 2018, 01:38:11 pm

Title: FGBS-001 : how to get rid of start/end of movement notifications ?
Post by: SystemaX on May 15, 2018, 01:38:11 pm
Hello !
I use the entries IN1 and IN2 of an FGBS-001 to notify me, on VeraPlus, if either of my two garage doors opens or closes (2 potential-free switches).

It works fine but I would like to get rid of the additional notifications that I get, indicating start and end of movement, as if the FGBS was connected to a motion sensor.

Any ideas ?
Thanks ^^
Yves
Title: Re: FGBS-001 : how to get rid of start/end of movement notifications ?
Post by: SystemaX on May 24, 2018, 06:18:44 am
Thanks for your reading, too bad nobody had a solution...

This box is too much "prise de tete" for me, I sent it back and bought another brand (eedomus+, where each and every parameter of the FGBS is known and explained and easy to change without creating it, giving it's number & size. Really a nice box...).

I can not afford to spend hours on each device to connect.
Have fun nevertheless, sure a lot of things to do !
Yves