The Vera Community forums have moved!
General => Lighting & Load Control => Topic started by: Roger2016 on October 16, 2016, 05:39:50 am
-
Hi everyone,
I need some help to set up the Z-Wave.Me Wall Controller with the latest firmware to control the scenes in my Veraedge.
I want to press button 4 (bottom right) and activate a scene (#31) in Veraedge.
I have tried setting the following:
Configurations (Device Option of wall controller):
Variable 1 - 0 (value)
Variable 2 - 0 (value)
Variable 11 - 4 (value)
Variable 12 - 4 (value)
Variable 13 - 4 (value)
Variable 14 - 4 (value)
Configurations (Scenes [under the wall controller menu])
trigger: scene #31
Configurations (Scenes [Vera menu])
Scene (#31) - whenever wall controller button 4 is pressed.
Can someone advise on what else must I do to make this work?
Thanks in advance!
-
I think you have to set variable 14 to value 8. Then associate group id 5 to the scene you want to run.
-
Hi trygve,
Thanks for the advice.
What do you mean by "Then associate group id 5 to the scene you want to run"?
As I am a beginner, could you elaborate more on what exactly must I do and what it means after doing that step?
I still don't see any link...for the entire setup.
Thanks.