The Vera Community forums have moved!

General => Temperature Monitoring & HVAC Control => Topic started by: Excrewman on February 18, 2017, 12:25:48 pm

Title: Problems linking stella Z radiator valve to Vera Plus
Post by: Excrewman on February 18, 2017, 12:25:48 pm

I have a vera plus which was linked up to two stella z radiator valves, I had to do a hard reset of my vera and now I can't get the stella z valves to link. Each time I press the button on the stella for 5 seconds like the manual says i get constant flashing green LED and the vera doesn't detect the valve. IS there an issue because they were previously linked maybe? I thought the hard reset would have excluded them so it should be a straight forward inclusion when I rebuilt the vera.

Any ideas?

Title: Re: Problems linking stella Z radiator valve to Vera Plus
Post by: bogdanf on September 04, 2018, 03:46:01 pm

The hard reset on Vera will only erase the info from the Z-Wave chip of the controller.
On the Stella device, you will still need to perform the exclusion.