Hi Kalapa, Im sorry that the lock did not work and thanks for bringing it to my attention.
In fact, I have only programmed but not tested the lock on a physical zwave lock. Basically I run an HTTP GET command to lock like this:
Where 192.168.2.2 is the VERA IP and 55 is the Lock Device ID
I would appreciate it if you or anybody else at the forum can help me correct the above statement (I am assuming it doesn't work based on your feedback). Please try to put it in your browser to check if it is working or not.
I did buy a zwave lock recently, but I am still stuck on getting it to be configured on vera! It is frustrating and I will figure it out soon.
I have an update about the iPhone app. It is ready, I also set up remote access on the iPhone and the iPad app. I am going to test the iPhone app one last time tomorrow and then I will be submitting it to apple.
Regarding the Alarm, to be honest, I do not have plans for that as of now. I will be working on Voice Commands and KNX Integration next.