Author Topic: Fortrezz SSA3 red siren wrong configuration  (Read 1320 times)

Offline sirpinky

  • Sr. Newbie
  • *
  • Posts: 35
  • Karma: +0/-0
Fortrezz SSA3 red siren wrong configuration
« on: July 03, 2014, 10:10:44 am »
Hi guys, need some help with configuring this device.
It shows up as:
urn:schemas-micasaverde-com:device:Siren:1
D_Siren1.xml

which makes it have on/off button, and no dimmer. (need the dimmer if you want to turn on only light).

I change it to:
D_DimmableLight1.xml
urn:schemas-upnp-org:device:DimmableLight:1

and save, it reloads correctly and immediately do another reload and goes back to the siren settings.

It seems it is being auto-configured again and again every time I change it.

I had this issue when I purchased it, and vera support used remote to connect to my vera and fixed it for me.
After last night's servers upgrade (not sure if it is the reason) I had to reboot my vera a couple of times until it finally turned on and this problem is back again.

Anyone knows why it would not keep my settings and re-configure it as a siren every time? Is there a flag somewhere to tell it not to auto-configure this device?

Thanks!

Offline sirpinky

  • Sr. Newbie
  • *
  • Posts: 35
  • Karma: +0/-0
Re: Fortrezz SSA3 red siren wrong configuration
« Reply #1 on: November 26, 2016, 03:06:06 pm »
Well, upgraded my controller to vera plus - same issue still here...

Anyone knows how to set it up to be a dimmer again?

Thanks.