Author Topic: Basic Event Logging Problems - TempLogFileSystemFailure  (Read 9907 times)

Offline YzRacer

  • Full Member
  • ***
  • Posts: 137
  • Karma: +0/-0
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #15 on: January 02, 2015, 06:07:13 pm »
Thanks for the idea on the crontab! I poked around at some of the .sh files and it seems changing the rotation schedule wouldn't be very hard. I am more interested in getting my Lua log over to my syslog so I can keep a better eye on the history. I did a test with:

while true do tail lualog | logger -t 'Luup'

That worked well at casting my log into syslog, but of course only runs when I perform that command directly in the terminal. I did notice some odd behavior from this, perhaps from too much logging going on, but it can be grep for finer control. Does anyone think it would be an issue to have this running all the time? I was also considering modifying the files required to just push the lualog out on syslog, but that route seems slightly more complicated.

Offline mvzut

  • Sr. Newbie
  • *
  • Posts: 32
  • Karma: +1/-4
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #16 on: March 09, 2015, 10:08:43 am »
Any news on this?

I am experiencing the same problems: "Cannot write user data" every six minutes. After a restart, it is usually gone for a few hours, but then the problems start again. Everything keeps working fine though, and I don't get unexpected restarts. But it is very annoying and gives me the feeling something is not right. Moreover, I cannot use the alerts overview on my Dashboard anymore, since it is always filled with 10 times the same message.

I have sent an email to Vera support as well, hopefully they can help me. But any help from other users is also very welcome!
« Last Edit: March 09, 2015, 12:33:54 pm by mvzut »
Vera Edge - 5 x Zwave module (switch/door/water/siren) - RFXtrx interface - ~30 KAKU modules (switch/PIR/smoke) - Netatmo - 6 x Philips Hue - P1 Smart Meter - Opentherm Gateway - Logitech Harmony Hub - 2 x Foscam R2 - 2 x Hikvision DS-2CD2132F-I - Imperihome

Offline greenberry

  • Sr. Newbie
  • *
  • Posts: 37
  • Karma: +0/-0
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #17 on: March 15, 2015, 04:25:20 am »
Same problem here too, after installing latest firmware and moving my whisper data and logs to the same usb stick.

Offline 2bitoperations

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #18 on: March 19, 2015, 07:40:59 pm »
I've been seeing this frequently *without* any USB stick logging - several times per hour

Offline greenberry

  • Sr. Newbie
  • *
  • Posts: 37
  • Karma: +0/-0
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #19 on: April 06, 2015, 08:26:51 am »
I've been seeing this frequently *without* any USB stick logging - several times per hour

Yes I thin k you're right. I've moved the logs to another flash-drive,but it's still happening.
Support told me it could be one of my (not in use/un-reachable/plugin) camera's, so I've removed them for now.
But the message is still here.

Offline konstsch

  • Sr. Newbie
  • *
  • Posts: 20
  • Karma: +0/-2
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #20 on: June 09, 2015, 04:29:33 pm »
I have similar trouble. I use flash-drive as well.
My z-wave net include only two fibaro's devices.

Offline ssubo

  • Sr. Newbie
  • *
  • Posts: 21
  • Karma: +0/-0
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #21 on: August 11, 2015, 12:28:30 pm »
I'm also seeing the "cannot write user data" message every 6 minutes. Any updates on this issue?

Offline hmspain

  • Hero Member
  • *****
  • Posts: 513
  • Karma: +16/-8
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #22 on: August 11, 2015, 12:37:52 pm »
I'm also seeing the "cannot write user data" message every 6 minutes. Any updates on this issue?

Knowing how EXTREMELY limited the disk space is on Vera, I would recommend logging into the Vera as "root" and "df -h" to check the partition utilization.  You don't want ANY of your partitions to be reading Use% 100% :-).

Putting you log files on a USB drive might cause as many problems as it tries to solve, but (if it works) is a step in the right direction keeping those partitions free for upgrades and other Vera processes.
VeraPlus (1); Cameras (6), Sirens (2), Hue Bulbs/Strips/Blooms (42), Fan Dimmer (6), Aeon 4-in-1s (10), Water Sensors (3), Z-Wave Switches (20), Nest Smoke/CO Protects (5), Nest Thermostat Gen3 (1), HEM Gen2s (2)

Offline ssubo

  • Sr. Newbie
  • *
  • Posts: 21
  • Karma: +0/-0
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #23 on: August 13, 2015, 11:43:35 pm »
I did that and I have 2 100% rows... Any way to fix this? Take a look:

Filesystem                Size      Used Available Use% Mounted on
/dev/root                 4.5M      4.5M         0 100% /rom
tmpfs                    30.5M      4.2M     26.3M  14% /tmp
tmpfs                   512.0K         0    512.0K   0% /dev
/dev/mtdblock7           11.0M      7.3M      3.7M  66% /overlay
overlayfs:/overlay       11.0M      7.3M      3.7M  66% /
/dev/mtdblock8            4.4M      4.4M         0 100% /mios

Offline RichardTSchaefer

  • Master Member
  • *******
  • Posts: 9099
  • Karma: +690/-126
    • RTS Services Plugins
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #24 on: August 14, 2015, 03:11:49 am »
Those two are OK ... they are read-only partitions that contain the Vera Software.

Offline hmspain

  • Hero Member
  • *****
  • Posts: 513
  • Karma: +16/-8
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #25 on: August 14, 2015, 08:03:12 am »
Those two are OK ... they are read-only partitions that contain the Vera Software.

"Those two" reading 100% full; good point Richard, thank you!

That /overlay partition is used (among other things I'm sure) for upgrades (my understanding).  A little tight for my taste, but just so you know :-).
VeraPlus (1); Cameras (6), Sirens (2), Hue Bulbs/Strips/Blooms (42), Fan Dimmer (6), Aeon 4-in-1s (10), Water Sensors (3), Z-Wave Switches (20), Nest Smoke/CO Protects (5), Nest Thermostat Gen3 (1), HEM Gen2s (2)

Offline hmspain

  • Hero Member
  • *****
  • Posts: 513
  • Karma: +16/-8
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #26 on: August 14, 2015, 11:02:07 pm »
I'm also seeing the "cannot write user data" message every 6 minutes. Any updates on this issue?

I was feeling smug not getting this error... until tonight LOL.  Something to do with my USB thumb drive?

root@MiOS_30013035:~# df -h
Filesystem                Size      Used Available Use% Mounted on
/dev/root                 4.5M      4.5M         0 100% /rom
tmpfs                    62.2M      1.9M     60.3M   3% /tmp
tmpfs                   512.0K         0    512.0K   0% /dev
/dev/mtdblock7           11.0M      8.0M      3.0M  73% /overlay
overlayfs:/overlay       11.0M      8.0M      3.0M  73% /
/dev/sda1               506.2M     38.4M    442.0M   8% /tmp/log/cmh
/dev/mtdblock8            4.1M      4.1M         0 100% /mios
root@MiOS_30013035:~#
VeraPlus (1); Cameras (6), Sirens (2), Hue Bulbs/Strips/Blooms (42), Fan Dimmer (6), Aeon 4-in-1s (10), Water Sensors (3), Z-Wave Switches (20), Nest Smoke/CO Protects (5), Nest Thermostat Gen3 (1), HEM Gen2s (2)

Offline watou

  • Hero Member
  • *****
  • Posts: 866
  • Karma: +43/-12
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #27 on: August 15, 2015, 04:31:51 am »
My VeraEdge on latest firmware is constantly dumping these messages into my LuaUPnP.log file along with a long directory listing.  I don't have a USB thumb drive attached.

Code: [Select]
01 08/15/15 9:24:23.096 UserData::WriteUserData saved--before move File Size: 8780 save size 8780 <0x76910520>
02 08/15/15 9:24:23.096 UserData::TempLogFileSystemFailure start 0 <0x76910520>
02 08/15/15 9:24:23.118 UserData::TempLogFileSystemFailure 4714 res:1
-rw-r--r--    1 root     root            33 Aug  1 10:46 /etc/cmh/HW_Key
....


No explanation from the developers yet, after months I think.  Wish they would fix it!

Offline hmspain

  • Hero Member
  • *****
  • Posts: 513
  • Karma: +16/-8
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #28 on: August 15, 2015, 11:14:46 am »
My VeraEdge on latest firmware is constantly dumping these messages into my LuaUPnP.log file along with a long directory listing.  I don't have a USB thumb drive attached.

Code: [Select]
01 08/15/15 9:24:23.096 UserData::WriteUserData saved--before move File Size: 8780 save size 8780 <0x76910520>
02 08/15/15 9:24:23.096 UserData::TempLogFileSystemFailure start 0 <0x76910520>
02 08/15/15 9:24:23.118 UserData::TempLogFileSystemFailure 4714 res:1
-rw-r--r--    1 root     root            33 Aug  1 10:46 /etc/cmh/HW_Key
....


No explanation from the developers yet, after months I think.  Wish they would fix it!

I suspect this is one of those "Put a small piece of electrical tape over the light" type fixes we hear when the bogus engine light came on in earlier cars... hehe
VeraPlus (1); Cameras (6), Sirens (2), Hue Bulbs/Strips/Blooms (42), Fan Dimmer (6), Aeon 4-in-1s (10), Water Sensors (3), Z-Wave Switches (20), Nest Smoke/CO Protects (5), Nest Thermostat Gen3 (1), HEM Gen2s (2)

Offline pwlivewire

  • Jr. Member
  • **
  • Posts: 58
  • Karma: +0/-1
Re: Basic Event Logging Problems - TempLogFileSystemFailure
« Reply #29 on: August 27, 2015, 05:50:10 pm »
this is crippling! how is this not solved, my controller is reloading every 10 minutes, scenes and triggers are a mess not to mention the mess Ui7 has made of my devices.. furious with the tardy support and service, and this is public release as well! not even BETA!. I'm looking elsewhere and wont be buying vera again. 
Paul