Does anyone know if it's possible, and simple, to be able to set the blinds to be - say - 75% of the way down?
Obviously code like this:
Will set them fully down / closed... but I wondered if it was simple enough to set an integer / percentage position? I don't even know if the blinds would have a clue what that even is... I'm kinda suspecting not but there is something in there that remembers a "My" position... that must know where the blind is, I suppose?
The problem being that the blinds are different sizes (widths) and it seems they can move at different speeds, so you don't want to just set them all going down for, say, 10 seconds... they'll very likely end up at different positions, therefore I want say "each blind should go to 75% of its drop".
Apparently there is a "Target" variable... with an on / off light you can do "SetTarget" and it's either 1 or 0... is it the same with the blinds?
This code can be sent successfully via Vera's admin. console, but it does nothing (it was a shot in the dark anyway):