Author Topic: Qubino smart meter - anyone using?  (Read 1018 times)

Offline TheRedPill

  • Full Member
  • ***
  • Posts: 109
  • Karma: +0/-0
Qubino smart meter - anyone using?
« on: August 06, 2016, 08:50:19 am »
http://www.vesternet.com/z-wave-qubino-smart-meter-zmnhtd1-plus

Looks good, but cant find any info on using with Vera

Offline rmitsos

  • Sr. Newbie
  • *
  • Posts: 43
  • Karma: +1/-1
Re: Qubino smart meter - anyone using?
« Reply #1 on: October 27, 2016, 03:53:30 am »
I asked same thing on Vesternet and I got a negative response

My question

"What is the difference between the bi-stable and the contactor switch ? I need to switch a load of ~ 4k W (electrical water heater) which uses a double switch (live+neutral), which one suits better ? Do u have any feedback from Vera users that have managed to add them in their network (smart meter, contactor, bi-stable) ?"

The answer I received

"There is no difference between bi-stable and contactor switch. BICOM or IKA are only devices that are compatible with Smart Meter ? in your case you can use BICOM.
From our experience Smart Meter is not supported by Vera"



It is pitty though because their switches are the only capable for handling high loads (32A). It'd be nice for Vera to support them.

Offline pilot1946

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Re: Qubino smart meter - anyone using?
« Reply #2 on: February 12, 2017, 12:32:36 pm »
Hi,
I've bought this meter, but still haven't finished to configure it.
The difference between bistable switch and the contactor switch is the "memory" of the state. bi-stable switch remain in the same state even if the power source is disconnected. The BICOM432 is very interesting solution due to IR port controll, but you can use every relay or contactor switch with 230V control voltage and up to 3W power consumption rating.

Offline ElCid

  • Sr. Newbie
  • *
  • Posts: 20
  • Karma: +1/-5
Re: Qubino smart meter - anyone using?
« Reply #3 on: March 10, 2017, 06:15:38 am »
the 32a contactor is just a contactor it is not a z-wave  or zigbee device it would hard wire into smart meter. the bi stable sw is controled by IR

Offline AntRib

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-1
Re: Qubino smart meter - anyone using?
« Reply #4 on: May 03, 2017, 03:10:19 am »
Z-Wave works great :)

Offline rmitsos

  • Sr. Newbie
  • *
  • Posts: 43
  • Karma: +1/-1
Re: Qubino smart meter - anyone using?
« Reply #5 on: May 11, 2017, 04:58:36 am »
Z-Wave works great :)

What do u mean works great, did you manage to connect it to Vera ? As what it appears ?

Thank you,

Online zedrally

  • Hero Member
  • *****
  • Posts: 663
  • Karma: +18/-29
  • Black Cat Controllers & Control Systems
    • Black Cat Control Systems
Re: Qubino smart meter - anyone using?
« Reply #6 on: May 11, 2017, 05:08:49 pm »
It's a troll.
Honorable Member of the outrageous & epic smite thread. Smite me, I dare you.
Living in the Land of Oz, give me a vegemite sandwich. Home Seer, Vera Lite & Edge, Popp, Black Cat Smart Hub & Vera G, Black Cat Lite 1 & 2's, then some  Black Cat Cat's Eye PIR's & Door-Window Sensors.

Offline rmitsos

  • Sr. Newbie
  • *
  • Posts: 43
  • Karma: +1/-1
Re: Qubino smart meter - anyone using?
« Reply #7 on: May 17, 2017, 06:24:34 am »
It's a troll.

It's a troll and I'm a dumb-@ss  ::) ... Thank you mate

Online zedrally

  • Hero Member
  • *****
  • Posts: 663
  • Karma: +18/-29
  • Black Cat Controllers & Control Systems
    • Black Cat Control Systems
Re: Qubino smart meter - anyone using?
« Reply #8 on: May 17, 2017, 05:08:29 pm »
It's the dumb ass above you, ::)
Honorable Member of the outrageous & epic smite thread. Smite me, I dare you.
Living in the Land of Oz, give me a vegemite sandwich. Home Seer, Vera Lite & Edge, Popp, Black Cat Smart Hub & Vera G, Black Cat Lite 1 & 2's, then some  Black Cat Cat's Eye PIR's & Door-Window Sensors.