I had some minor fits upgrading. Had to do a hard reset of the controller to get it to do a truly clean install. Because of that, I had to plug it into my router to configure the Wi-Fi. Then I could restore from the backup. Was working fine so I unplugged it from the router, moved it to its normal place, it booted up fine, things still working, so I went to bed.
At 5:30 when I awoke, the PLEG to switch from Night to Home did not execute (no notification that the cameras were disarmed). VeraMate could not connect so I could not confirm the heating was raised from 65 to 68. Looking at the thermostat, still set at 65. Looking at the controller, it was back to no WAN (just like after the hard reset). Rebooted. It came up fine and has been working since.
It reminds me to boot, boot, boot when making radical changes and patiently wait for LUUP reloads a couple of times when making minor changes. After a while it settles down until I tinker and "break" it again
Vera 3, UI7 1.7.919, CT30 thermostat, Everspring motion detector, GE/Jasco switch, Leviton outlet, Vision door sensor, Insteon garage control, Blue Iris, Sricam SP011, iPhone locator, APCUPSD, VeraMate, VeraAlerts, PLEG, House Modes, Countdown Timer, DVR, Virtual & Multi Switch, Weather, System Mon.