Author Topic: Bridging 2 Vera Edges  (Read 159 times)

Offline AaronBott

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Bridging 2 Vera Edges
« on: April 20, 2017, 01:08:36 pm »
Hi all,

i have had a vera edge for a while now in my workshop and now want to start to automate the house.  I have purchased another edge and got them both on the latest firmware.  I have attempted to set them in bridge mode using the add device ->upnp device route but it never detect the other vera box.
Is there something fundamentally stupid i am doing or does this just not work?

thanks

Aaron