Vera secure and 2gig DW10

[agh1701]

Does anyone know if verasecure supports both loops in the DW10 sensor.  I am sure it supports loop 2 being the internal mag switch.  I am more interested if it supports loop 1, the external normally closed circuit for external mag switch.  On a 2gig system the same sensor is added twice, once of each loop supporting 2 windows.

Does anyone know?

[Sorin]

Hi there,


I've just tested the 2GIG DW10 and it seems that for the moment it can only be used with the magnet. it's detected as 1 single device, and the wire probes do not seem to work.


I will report this to our development team, so it can be added as a new feature in the upcoming firmware updates.

[agh1701]

Thanks!  It will cost me extra to start up my Vera secure however, this could be real important to someone upgrading a 2gig or Honeywell system using there existing sensor setup.

[ZW-Tom]

Hi there,


I've just tested the 2GIG DW10 and it seems that for the moment it can only be used with the magnet. it's detected as 1 single device, and the wire probes do not seem to work.


I will report this to our development team, so it can be added as a new feature in the upcoming firmware updates.

And here it is, 8 MONTHS later, with no solution in any firmware updates!
It would be better if you just said "we will never provide an update in your lifetime if you are over age 60".